L2910 2 Post Car Lift 9,000 LB OVER HEAD Auto Hoist Clear Floor 220 VOLT

Description

We will charge 0 for shipping to residential or farm address. Buyer need to have forklift to unload or pick up from local Fedex freight terminal
Auto Car Lift  L 2910
Features   220V  60HZ  1PH   3HP MOTOR
Come with adjustable pads. Truck adapters optional
Safety Mechanism:
•Double Point Safety Lock Release
•Automatic arm lock restraints
•Relief valve built in power pump to prevent overloading
•Door guards protection rubber
•Up-limit switch to protect cylinders working stroke used in safe length scope
•Heavy duty 5/16" diameter cable and 4.56" pulley reduce high stress on synchronization process and increase cable life
•Stiffened base plate 15/32" thickness
•Ultra high molecular self lubricating nylon slider ensures carriage smooth moving up and down
•Anchor bolts/mounting hardware included
Control System
•Lifting operation by pressing "UP" button on motor
•Manual lowering operation by pressing lever
•Relief valve built in power pump to prevent overloading
•Lifting Capacity: 9,000 lbs
•The overall Height  145 21/32"
•The overall Width  133-1/4"
•Column Width    10.59"
.Distance between 2 post  106-5/16"
Overall width 131-1/2"
•Base Width   14-9/16"
•Column Thickness of Steel    11/64"
•Carriage Thickness of Steel   3/16"
•Arms Thickness of Steel     15/64"
•Front Arm    29.9"-47.2"
•Rear Arm     29.9"-47.2"
•Min pad height: 3-7/8"
•Lift height max: 74-13/16"
•Drive-thru width clearance: 99-7/32"
•Time to full rise: 55 sec
•Shipping Weight: 1370 lbs
Site Selection
Before installing your
auto lift
, check the following:
• Lift Location: Always use architect’s plans when available.  Check layout dimension against floor plan requirements making sure adequate space is available.  Your lift
requires a 220v, 30amp, single phase, grounded electrical source.  There should be room enough to operate the lift in a safe manner and without restrictions.
• Overhead Area: The area where the lift will be located should be free of overhead obstructions such as heaters, building supports, electrical lines, doors, lights, etc.
• Floor Area: Visually inspect the site where the lift is to be installed and check for cracked or defective concrete.
Floor Requirements
• A level floor is suggested for proper installation and level lifting.  Small differences in floor slopes may be compensated for by proper shimming.  If a floor is of questionable slope, consider a survey of the site and/or the possibility of pouring a new level concrete slab.
• New concrete must be adequately cured for at least 30 days.
DO NOT
install auto lift on any asphalt surface or any surface other than concrete.
DO NOT
install auto lift on expansion seams or on cracked or defective concrete.
DO NOT
install auto lift on a second/elevated floor without first consulting building architect.
DO NOT
install auto lift outdoors unless special consideration has been made to protect the power unit from inclement weather conditions.
Concrete Specifications
2-post lifts (under 12,000 LB. capacity):
Four (4) inches of concrete at 3000 PSI
12,000 pound two-post lifts (and higher capacity):
Six (6) inches of concrete at 3000 PSI is required.
We do not ship to Alaska, Hawaii, Puerto Rico, PO Boxes, or APO/FPO addresses. WE CHARGE 15% RESTOCKING FEE If you want to return or cancel the order after we ship out the item.